Electrolux esf 610 service manual


















To fill the dishwasher with detergent proceed as follows:. Open the dispenser lid by pulling the catch D. Add the detergent according to the recommendations in the programme chart.

As all detergents are not the same, you should also consult the instructions on the packet specially for tablets. To help correctly dose the right amount of detergent, inside the container there are two reference marks:.

Always close the lid. Ifthe programme has a prewash add the required detergent over the lid of the dispenser. Insufficient quantities of detergent will produce poor washing results, whereas an excessive amounts of detergent will not improve washing results and is also wasteful.

Using no more than the correct amount also contributes to reducing pollution. Phosphate free detergents with enzymes. In these low-alkaline compact powders the environment unfriendly components have been replaced by natural enzymes and other more biodegradable substances.

These new compact powders are generally phosphate-free. This will avoid lime deposits on crockery and the inner tub. Using your appliance. Loading your appliance. Before placing dishes in the machine, remove any scraps of food, to avoid clogging the filters and consequently reducing the performance. Do not load very small items which can fall through the baskets. Open the door and slide out the baskets to load the dishes. The lower basket.

The lower basket is designed to take saucepans, lids, plates up to 27cm in diameter , salad bowls, cutlery etc. Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the upper spray arm can turn freely. The two rear rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and bowls. To bring them back to the standing position, just pull them up again.

The cutlery basket. Long bladed knives stored in an upright position are a potential hazard. Take care when loading or unloading sharp items such as knives.

Cutlery should be placed in the removable cutlery basket with the handles facing downwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. Mix spoons with other cutlery to prevent them from sticking together.

The cutlery basket can be placed either to the left or to the right of the lower basket. The upper basket. The upper basket is designed for plates dessert plates, saucers, dinner plates of up to 24 cm in diameter , salad bowls, cups and glasses; Glasses with long stems can be placed upside down in the raised cup racks.

Larger plates dinner plates up to 24 cm in diameter must be loaded in the front part of the upper basket. Light items plastic bowls etc. Before closing the door, ensure that the spray arms can rotate freely. Adjusting the height of the upper basket. If washing very large plates over 27 cm and up to 31 cm in diameter you can load them in the lower basket after moving the upper basket to the higher position.

To move to the higher position proceed as follows:. Move the front runner stops A of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops A in their original position.

When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. Hints and tips. To save energy.

Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme see Programme Chart on the following pages , so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme.

Do not prewash dishes under running water. For best washing results:. Before loading remove all scraps of food and soak very heavily soiled pots and pans. Arrange saucepans, cups and glasses etc. Tilt items with convex or concave surfaces so that the water drains off easily. Avoid contact between the dishes as far as possible. You will improve drying results by leaving the dishwasher door ajar for at least minutes as soon as the programme finishes.

Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.

The following items should not be washed in the dishwasher unless they are sold as dishwasher proof :. Cutlery with wooden or horn handles or glued parts. Certain types of decoration can discolour when washed in a dishwasher. Crystal-ware and plastic objects, if not guaranteed dishwasher proof should be washed by hand. Certain types of glass can also become opaque after being washed several times ina dishwasher.

A chemical reaction can occur between silver cutlery and stainless steel cutlery. As a precaution, do not wash together. Aluminium tends to go black, copper, pewter and brass tend to stain. If in doubt check with manufacturer of the item.

When buying new dishes, ensure that they are dishwasher proof. Washing programmes. Operating sequence. Check the filters. Ensure they are clean and properly positioned see cleaning instructions. Check that there is rinse aid and salt. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the basket back into the machine. Ensure that the spray arms can rotate freely. Close the detergent dispenser lid.

Close the dishwasher door. Set the programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker. Start the programme. If you wish to interrupt the wash programme at any time press the button again.

At the end of the washing. When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. Good luck to the repair! Please do not offer the downloaded file for sell only use it for personal usage! Looking for similar electrolux manual?

Document preview [1st page]. Please tick the box below to get download link:. To open the door press the catch in the top of the recess and pull the door toward you at the same time. The dishwasher is equipped with a water softener designed to remove minerals and salts from the water supply, which would have a detrimental or adverse effect on the operation of the appliance.

Water hardness is measured in equivalent scales, for example German, French degrees, and parts per million. The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.

With a screwdriver turn the selector on the upper front corner of the machine until the level required corresponds with the marker. If your water is "level 0" it is already soft and therefore there is no need to use salt. All other types of salt not specifically designed for use in dishwasher, specially table salt, will damage the water softener.

Only fill with salt just before starting one of the complete washing programmes not the Rinse and Hold programme. This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion. To fill with salt, unscrew the cap of the salt container. Pour about 1 litre of water inside the container, or until it is full this is necessary only before filling with salt for the first time.

Then using the funnel provided, pour in the salt until the container is full approx. Do not worry if water over flows from the unit when filling with salt, this is quite normal. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket.

The salt container has always some water inside which will normally overflow when refilling with salt. If you are using salts that take longer to dissolve then this can take longer. The function of the dishwasher is not affected.

Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up.

Forgot password? Instead, contact your nearest service center! Translate this page:. Sehol semmilyen csopogest, korrodalt alaktreszt nem lattam. Similar manuals:. If you want to join us and get repairing help please sign in or sign up by completing a simple electrical test or write your question to the Message board without registration.



0コメント

  • 1000 / 1000